Toshiba MMK-AP0073H Manuel D'installation page 11

SMMS High-Wall Type
How to remove the drains cap
Clip the drain cap by needle-nose pliers and pull out.
How to fix the drains cap
1) Insert hexagonal wrench (dia. 4mm) in a centre head.
2) Firmly insert drains cap.
No gap
Firmly insert the drain hose and drain cap; otherwise, water may leak.
How to remove the drain hose
1) Remove the front panel.
2) Remove the screws of drain hose.
3) Pull out the drain hose.
▼ In case of right or left piping
• After scribing slits of the front panel with a knife or a marking-off pin, cut them with a pair of nippers or an
equivalent tool.
4mm
Do not apply lubricating oil (refrigerant
machine oil) when inserting the drain cap.
Application causes deterioration and drain
Insert a hexagon
leakage from the plug.
wrench (4 mm)
CAUTION
Slit
– 10 –
How to fix the drain hose
1) Put the drain hose.
2) Screw the drain hose to the indoor unit.
3) Install the front panel.
Installation Manual
EN
10-EN