Skil PWR CORE 20 JB4712B-00 Guide D'utilisation page 12

Assembling the Inflator/Deflator
Assembly for Using as a Inflator
Remove the blower tube.
a.
d. Align the raised portions in the inflator/
deflator assembly with the grooves on the
blower housing. Push the inflator/deflator
assembly onto the blower housing as far as
it could reach. (Fig.3)
e. Rotate the inflator/deflator assembly
clockwise to lock into place. Pull on the
assembly to ensure it is locks in place
securely. (Fig.3)
To remove the assembly, rotate the inflator/
b.
deflator assembly counterclockwise, then
pull it straight out from the blower to remove
it.
Assembling the Inflator/Deflator
Assembly for Using as a Deflator
a. Align the raised portions on the air inlet with
the grooves on the inflator/deflator assembly,
then insert the assembly onto the blower
over the air inlet as shown. (Fig.4)
b. To remove the inflator/deflator assembly, pull
it away from the blower.
To Attach/Detach Battery Pack
(Fig .5)
To attach the battery pack:
Align the raised rib on the battery pack with
the grooves of the blower, and then slide the
battery pack onto the blower.
NOTICE: Make sure that the latch on the
battery pack snaps into place and that the
battery pack is secured to the blower before
beginning operation.
To detach the battery pack:
Depress the battery-release button located
on the front of the battery pack to release the
battery pack. Pull the battery pack out and
remove it from the blower.
12
Fig. 3
Groove
Raised Portion
Fig. 4
Fig. 5
2
Battery-Release Button
Detach
Attach