Operating Instructions - Skil PWR CORE 20 JB4712B-00 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc, can cause a short
circuit.
WARNING
could result in serious personal injury.
WARNING
modification is misuse and could result in a hazardous condition leading to possible serious
injury.
WARNING
assembling parts, making adjustments, cleaning, or performing maintenance.
This blower must be used only with the battery packs and chargers listed below:
2Ah
SKIL BY519701
SKIL BY519702
NOTICE: Please refer to the battery and charger manual for detailed operating information.
Assembling the Blower Tube for
Using as a Blower
a. Align the raised portions in the blower tube
with the grooves on the blower housing. For
your convenience alignment, there are two
marks "—" indicated on the blower tube,
each facing rightly to a raised portion inside
the tube. Push the tube onto the blower
housing as far as it could reach. (Fig.2)
b. Rotate the blower tube clockwise to lock into
place. Pull on the tube to ensure it locks in
place securely. (Fig.2)
c. To remove the blower tube, rotate the blower
tube counterclockwise, then pull it straight
out from the blower.
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced . Use of this product with damaged or missing parts
Do not attempt to modify this blower or create accessories not
recommended for use with this blower . Any such alteration or
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the blower when
Battery Pack
2.5Ah
SKIL BY519703
4Ah
SKIL BY519601 SKIL BY519603
Fig. 2
Groove
Charger
5Ah
SKIL SC535801
SKIL QC536001
1
Mark "—"
Raised portion
2
11