Signature Control Systems EZ Pro Jr. Indoor 8204 Guide D'installation Et De Programmation page 26

FCC RULES
This electronic irrigation controller generates and uses radio frequency energy and if not installed and used properly,
that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception.
It has been type tested and found to comply with the limits for a Class B computing device in accordance with the
specifications in Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such
interference in a residential installation. However, there is no guarantee that interference will not occur in a particular
installation. If this controller does cause interference to radio or television reception, which can be determined by
turning the controller off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient the receiving antenna
Relocate the controller with respect to the receiver
Move the controller away from the receiver
Plug the controller into a different outlet so that the controller and receiver are on different branch circuits
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.
The user may find the following booklet prepared by the Federal Communications Commission helpful:
"How to Identify and Resolve Radio-TV Interference Problems"
This booklet is available from the U.S. Government Printing Office, Washington, DC 20402. Stock No. 004-000-00345-4.
CANADIAN RADIO INTERFERENCE REGULATIONS
NOTE: This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus set out in the radio interference regulations of the Canadian Department of Communications
WARRANTY
Limited Warranty
Signature Control Systems, Inc. warrants all electronic products to be free of defects in material and workmanship for a period
of two (2) years from the original date of purchase. In the event of such defects, Signature will repair or replace, at it's option,
the product or the defective part. This warranty does not extend to damage to a Signature product or part resulting from
accident, misuse, alteration, neglect, abuse, improper installation or normal wear and tear, or to exterior appearance and color.
This warranty extends only to the original user of the Signature product. If defect arises in a Signature product or part within
the warranty period, you should contact your installing contractor, Signature retailer, distributor, or Signature Control Systems,
Inc. Signature may, at its option, require that the product or part be returned to a Signature service point or your retailer or
distributor. Signature will determine whether the claimed defect is covered by the warranty. If coverage is found, the product
will be repaired or replaced. Please allow 4 to 6 weeks for completion of repairs or replacement and return of the product or
part. If a product or part is replaced, the replacement is warranted only for the remainder of the original product or part
warranty period.
22
.