Trevi DME 3228 Mode D'emploi page 11

METEO STATIONBATTERY & ADAPTEBATTERY & ADAPTER INSTALLATION
Home Receiver Unit:
Main Power Source: Plug in the 6.0V adapter into the adapter socket at the back for basic operation and continuous backlight.
Backup Power: Lift off the battery cover, install 3 pieces of AAA backup batteries according
to the polarity indicated, close the battery cover.
Remote Sensor:
Loosen the screws on the battery door with a small screwdriver, insert 2 pieces of AAA batteries
according to the polarity indicated. Replace the cover and tighten the screws.
ALTITUDE SETTING
After inserting batteries or adapter, the main unit will enter altitude setting mode directly. Press "
hPa, mb or inHg. Press "PRESSURE" to confirm. Then press "
to confirm and exit the setting. This allows the unit to provide a more accurate barometric pressure & weather forecast reading. (For
more information, see "WEATHER FORECAST & BAROMETRIC PRESSURE" section)
SETTING UP THE WIRELESS THERMO-HYGROMETER:
• For the first installation, always turn on the home unit and then the remote sensor. Set Channel 1 for the first remote sensor. Set
channel 2 and channel 3 for the 2nd and 3rd sensor.
• Press and hold CHANNEL/SEARCH button on main unit until a beep is sound to search for remote sensor.
• Press the Tx button on the back of remote sensor to transmit RF signal.
• When RF connection is established, the respective temperature & humidity of the selected channel will appear on the main unit.
WEATHER FORECAST & BAROMETRIC PRESSURE
The unit predicts weather condition of the next 12 – 24 hours based on the change of atmospheric pressure. The coverage area is
around 30 – 50 km. The weather forecast is based on atmospheric pressure change and is about 70-75% correct. As weather
conditions cannot be 100% correctly forecasted, we cannot be responsible for any loss caused by an incorrect forecast.
ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH
" or " " to enter your current altitude in meter or feet. Press "PRESSURE"
DME 3228 DME 3228
DME 3228 METEO STATION DME 3228 DME 3228
" or " " to select pressure unit in
P_11 P_11 P_11
P_11 P_11