Operation; Hand Grip - DNT Findoo Profiline Mode D'emploi

Operation

Operation
Turn on the power at the bottom side of the hand grip. The power indicator lights. The switch acts also as a
dimmer for the twin LEDs at the imager head.
Don't buckle the tube. The min. inside radius of the 16mm camera tube
should not go below 11 cm . The min. inside radius of the 9mm camera
tube should not go below 7 cm. This depends on the environmental tempe-
rature.
Monitor
Turn the monitor on with the Power ON/OFF button. The power indicator lights. Setup a suitable lighting on
the hand grip. In the next step setup channel 4 (CH4) for the transmission. Press and hold the Power ON/OFF
button to turn the monitor off.
The signal transmission from hand grip to monitor uses the connector if the monitor is mounted on the hand
grip. If not, the transmission is wireless via radio.
The range between monitor and hand grip is up to about 5m. In some cases the range can be
up to 10m. The transmission range may vary according to the weather, location, interference
and building construction.
2 LEDs
- 24 -
Selection photo or
video recording
Pressing repeately to
select channel 4