Installing Imager Head Cable - DNT Findoo Profiline Mode D'emploi

Getting started
Insert Batteries
Always exchange a complete set of new batteries.
Installing the imager head cable
To use the Findoo the imager head cable must be connected to the hand grip. Be sure that the key and slot are
properly aligned. Once they are aligned, fi nger tighten the knurled knob to hold the connection in place.
Key Slot
Installing the accessory
Accesssories for 16mm camera
The accessories consist of 3 parts, a mirror, a magnet and a hook, which are all attached to the imager head
on the same way. The accessories have 2 mounting positions on the imager head.
Insert the batteries into a battery box in the grip.
Remove the screw using a screwdriver on the lower side of the grip.
Slide the cover in the direction of the arrow.
Remove the battery compartment.
Insert four new batteries(included) into the slots of the battery compartment.
The proper orientation of the batteries is indicated on the compartment.
Install the battery cap into place.
- 22 -
knurled knob