Operation - DNT Scope IT Mode D'emploi

Getting started
Installing the accessory
The accessories consist of 3 parts, a mirror, a magnet and a hook, which are all attached to the imager head
on the same way. The accessories have 2 mounting positions at the imager head.
Inspect the inspection camera before use and correct any problems to
reduce the risk of serious injury from electric chock and other causes and
prevent tool damage.

Operation

Don't buckle the tube. The min. should not go below 15 cm.
Turn the monitor on with the power button.The Power LED indicates green. Setup a suitable lighting with the
LED brightness button. At the monitor you can adjust the contrast of the display, which also depends on the
pre-setting of the Twin LEDs
If the Image Orientation button is pressed, the picture orientation turns 180 ° or is mirrored.
ON/OFF
- 12 -
Twinlight LEDs