Getting Started; Insert Batteries; Installing Imager Head Cable - DNT Scope IT Mode D'emploi

Insert batteries

Always exchange a complete set of new batteries. .
Installing the imager head cable
To use the Findo the imager head cable must be connected to the hand grip. Be sure that the key and slot are
properly aligned. Once they are aligned, fi nger tighten the knurled knob to hold the connection in place.
Key Slot
The batteries are inserted into a battery box in the housing.
Remove the cover and the battery compartment. Slide the cover in the
direction of the arrow.
Remove the battery compartment.
Insert four new batteries(included) into the slots of the battery com-
partment. The proper orientation of the batteries is indicated on the
compartment.
Install the battery cap into place.
- 11 -

Getting started

knurled knob