Publicité
Les langues disponibles
Les langues disponibles
FIGURE 24
Maintenance / Storage
Maintenance
• To clean the Inversion Table, wipe down with a damp cloth. Do not use abrasive
cleaners or solvents.
Storage
• Remove the Angle Tether from the U-Bar located on the underside of the Table Bed.
• Loosen the Main Shaft De-Rattler Knob.
• Pull the height-selector locking pin, slide the Main Shaft in all the way, and engage the pin in
the storage setting.
• Rotate the table opposite from use until the table has turned 180 degrees and rests against
the Crossbar on the A-Frame.
• Pull up on the Spreader Arms to fold the A-Frame (Figure 24), leaving the A-Frame legs open
to a width of at least 12" for stability.
NOTE: This operation may pinch fingers if not done slowly and carefully.
Tipping Hazard: For upright storage, leave A-Frame open wide
enough to remain stable, or secure to the wall to prevent tipping.
In households with small children, the inversion table should be stored
WARNING
!
flat on the floor, not upright.
Publicité
