Publicité
Les langues disponibles
Les langues disponibles
FIGURE 16
FIGURE 17
1
2
3
1
De-Rattler Knob
Main Shaft Housing
2
3
Height-Selector Locking Pin
FIGURE 18
1
2
1
Crossbar
Proper Resting Position
2
Step 6
Depending on the model you have purchased, the items in this step will vary. The model of
your product can be found on the Serial Label, located on the back of the Table Bed.
Insert the Main Shaft into the Table Bed (NX-1300)
Contour L3: Use the Main Shaft with the EZ-Reach
Contour L5: Use the Main Shaft with the Deluxe EZ-Reach
• Ensure that the A-Frame is fully open and locked at the Spreader Arms (Figure 16).
• Rotate the Table Bed into its use position (Figure 17).
• Loosen the Main Shaft De-Rattler Knob at the base of the Main Shaft Housing.
NOTE: The De-Rattler Knob is an optional feature that prevents a slight shift when you invert.
Product security is not compromised if you choose not to tighten the knob.
• With the Height Adjustment Settings on the Main Shaft facing up, slide the end of the Main
Shaft into the Main Shaft Housing at the base of the Table Bed.
• Pull out the Height-Selector Locking Pin to allow the Main Shaft to slide in further and release
in the desired height setting. Refer to the Owner's Manual for more information on selecting
your height setting.
• The Main Shaft MUST REST against the Crossbar of the A-Frame (Figure 18).
NOTE: The Crossbar prevents the Table Bed from rotating forward when the user steps on
the Ankle Comfort Dial. If the Main Shaft does not rest on the Crossbar as shown in Figure
18, then the Table Bed has been assembled backwards onto the A-Frame. This must be
corrected before use.
™
Ratchet Ankle Lock System (NX-1630).
™
Ankle Lock System (NX-1630-B).
Publicité
