Altrad ATIKA KGSZ 305 N Notice Originale page 15

 Before each use, check
 Connection cables for defects (cracks, cuts, etc.)
Do not use any defective cables.
 the table insert for proper condition
Immediately replace a worn or damaged table insert.
 the saw blade for flawless condition
Do not use deformed or damaged saw blades.
 Connect the machine to a dust collection device when
sawing wood.
 To ensure a safe position of the saw it must be bolted down
on a solid surface (e.g. workbench or support frame) at
optimal working height.
Mounting on a workbench / work table:
 
Place the device on a level flat workbench or work
table.

An uneven surface may result in saw blade jamming
or inaccurate cutting.
You can adjust the front stand (40A) to compensate for
minor unevenness.
To do this, first loosen the lock nut for the front stand (40B)
and then turn the front stand (40A) in or out until the
crosscut and mitre saw is secure.
Make 4 holes in the workbench / work table matching the
holes in the base plate (39).
Bolt the device down.
Attaching the handle for the rotary table
Fasten the handle for the rotary table (7) to the extension
of the rotary table.
To swivel the table, press the handle down.
Removing the transport locking pin
Remove the transport locking pin before use
 Slightly push the handle (1) down.
 Pull out the transport locking pin (5).
Commissioning
Mains connection
Compare the voltage listed on the device type plate, e.g. 230 V,
with the mains voltage and connect the device to the
corresponding and proper socket.
Connect the machine via a 30 mA fault-current circuit breaker.
Use the connection or extension cable according to IEC 60245
(H 07 RN-F) with a core cross-profile section of at least
1.5 mm for cable lengths up to 25 m
 2
2.5 mm for cable lengths over 25 m
 2
On / Off Switch
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired or
replaced immediately by the customer service.
Switch on
Activate the On/Off switch (1A).
Switching off
Release the On/Off switch again.
Switching on the laser
Press the On/Off switch for the laser (1B).
Only switch on the laser when a work piece is on the
rotary table.
Dust/chip exhaustion
The wood dust generated during operation impedes
the necessary view and is harmful to health to some
degree.
Unless the machine is used outdoors, the dust bag (23) or a
chip exhaust system (e.g. portable dust remover) must be
connected.
Make sure that the connections for the dust extraction
and the dust bag (collecting device) are connected and
used correctly.
Dust bag

When using the dust bag:
push the dust bag (23) onto the exhaust neck (24).
regularly empty the dust bag.
Chip exhaustion
Connect a chip exhaust system or small vacuum cleaner
with suitable adapter to the chip exhaust neck (24) (dia. 44
mm).

Air velocity at the exhaust neck of the saw ≥ 20 m/sec.
Use a special exhaust device when exhausting dusts
that are especially harmful to health, carcinogen or
dry.
Attaching table extensions
Handle long workpieces with the help of the supplied
workpiece supports.
The workpiece supports can be mounted to the left and right
of the machine:
Secure the workpiece supports with the screws (19).

Safely support long work pieces with suitable means. For
example, use saw horses or similar devices to support
overhanging work pieces.
15