Kenwood TCM300 Instructions page 4

Only use the appliance for its intended
l
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with
these instructions.
before plugging in
Make sure your electricity supply is
l
the same as the one shown on the
underside of your toaster.
WARNING: THIS APPLIANCE
l
MUST BE EARTHED.
This appliance conforms to EC
l
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using for the first
time
Clip excess cord into the cord
l
storage clips in the base
Operate the toaster once on a
l
medium setting without bread.
(The lever will not stay down unless
the toaster is plugged in).
As with all new heating elements,
l
your toaster may emit a slight
burning smell when it is first
switched on. This is normal and
not a cause for concern.
key
a carriage lever (with 'Hi-Rise™' for
extra lift)
b reheat button with indicator light
c defrost button with indicator light
d cancel button with indicator light
e browning control
f crumb tray
g cord storage
to use your toaster
1 Plug the toaster into the power
supply.
2 Turn the browning control until
the desired setting aligns with the
line up mark on the body of the
toaster. Use a lower setting for light
toasting and for thin or dry bread.
3 Insert the bread, muffins, bagels
etc.
English
4 Lower the lever
l
l
l
1 .
l
5 Your toast will pop up
l
l
hints on using your
toaster
l
l
l
4
(The lever will not stay down unless
the toaster is plugged in).
The browning control setting lights
will illuminate up to the setting
selected and gradually go out to
show the toasting cycle progress.
The 'cancel'
illuminate.
The TURBO function is part
of the toasting cycle and will
automatically start when the
carriage lever is lowered and
locked.
To stop toasting during the cycle,
press the 'cancel' button, the toast
will pop up and the 'cancel' button
light will go off.
automatically, to raise it higher,
lift the lever.
Defrost button
To toast frozen bread - select
the desired setting, then lower
the bread and press the 'defrost'
button. The 'defrost' button will
illuminate.
Reheat
To warm toast that has popped
up but gone cold, lower the toast
then press the 'reheat' button.
The'reheat' button will illuminate.
Select a lower setting for light
browning or for dry bread.
When toasting a single slice of
bread, you may notice a variation
in toast colour from one side to the
other - this is normal.
Dry/stale bread toasts more quickly
than fresh bread and thinly sliced
bread toasts more quickly than
thickly sliced bread. Therefore
2 until it locks.
button will also