WARNING
!
Risk of electric shock. Use in dry locations only.
Turn power OFF at circuit breaker or remove fuse. Damage to this product caused by wiring with power
on voids the warranty.
Due to the risk of electric shock, a licensed electrician should install this power supply unit in strict
compliance with the National Electrical Code and any state or local code which may apply.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: ( 1 ) this device may not cause harmful interference, and ( 2 ) this device must
accept any interference received, including interference that may cause undesired operation.
Must be mounted at least 6 ft (1.8 m) away from wireless interference sources like microwaves, Wireless
Access Points (WAPs) etc.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following
two conditions:
•
This device may not cause interference.
•
This device must accept any interference, including interference that may cause undesired
operation of the device.
2 | N3 INSTALLATION GUIDE
P/N 3662351 Rev B
© 2019 Ketra, Inc. All rights reserved.