Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Range Hood Lamps
Replacing a LED Lamp
Turn off the range hood and allow the LED lamp to cool.
To avoid damage or decreasing the life of the new bulb, do
wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Push up on the lens and turn it counterclockwise.
3. Remove the bulb and replace it with a 120 V, 6.5 W maximum
LED bulb with a GU10 base. Turn it clockwise to lock it
into place.
4. Repeat steps 2 and 3 for the other bulb if needed.
5. Reconnect power.
Replacing the Infrared Heat Lamps
Turn off the range hood and allow the infrared heat lamp to cool.
To avoid damage or decreasing the life of the new lamp, do not
wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Twist lamp counterclockwise to remove.
3. Remove the lamp and replace it with a 120 V, 175 W
maximum, PAR38 IR lamp made for E-26 base. Twist lamp
clockwise to screw it into place.
RANGE HOOD CARE
4. Repeat steps 2 and 3 for the other lamp if needed.
5. Reconnect power.
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool
avoid scratching the surface.
Always wipe dry to avoid water marks.
Metal Filters and Drip Trays:
the front of range hood and pull down on the rear handle to
Remove grease drip tray.
hot detergent solution to clean.
Replace grease drip tray.
The range hood is equipped with a thermal protector to avoid
overheating conditions. If the range hood shuts off while in use,
move the blower switch to the Off position. Wait approximately
restart the range hood.
Cleaning
Stainless Steel Cleaner and Polish.
Mild liquid detergent and water.
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
A
A
A. Drip tray
A
Thermal Protector
13
Publicité
Table des Matières
