Complete Installation And Check Operation - Whirlpool JENNAIR JXW9030HP Instructions D'installation Et Guide D'utilisation Et D'entretien

3. Use UL listed wire connectors and connect black wires (B)
together.
4. Use UL listed wire connectors and connect white wires (A)
together.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
5. Connect green (or bare) ground wire from home power
supply to the green/yellow ground wire (D) in terminal box
using UL listed wire connectors.
6. Install terminal box cover.
7. Check that all light bulbs are secure in their sockets.
8. Reconnect power.
Complete Installation and Check
Operation
1.
2. Install heat lamps into heat lamp sockets.
3. Check operation of the range hood blower and lights. See
the "Range Hood Use" section.
G
A
A. Infrared lamp
D. Blower control switch
4. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
Disconnect power supply and check that the wiring is
correct.
NOTE:
read the "Range Hood Use" section.
F
D
E
B
E. LED light switch
F. LED lights
G. Infrared lamp controls
C
11