Titanium wi-1000 Guide D'utilisation page 15

3.1 Place the machine close to power socket.
3.2 make sure the voltage meets machine's electricity requirements.
3.3 Any extension cord used should meet the power rating of the machine.
3.4 Do not operate if the power cord is damaged.
3.5 Repair and service should be done by a qualified service technician.
Air nozzle cutter blade replacement steps.
4.1. Use the screw driver to remove the fix air nozzle screws. Refer fig. 11A.
4.2 Pulling out the air nozzle. Refer fig.11B.
4.3 Remove the air nozzle fix screws. Refer fig. 12.
4.4 Renew the new cutter blade (Caution: Be care of sharp blade may cut you
fingers).
4.5 Put the air nozzle back and use the screw driver to fix tightly of the 2 fix-
screws. Refer fig. 11,12.
CAUTioN: BLADE migHT BLUNT AFTER A LoNgER USE, PLE-
ASE CHECk oR REPLACE THE BLADE EVERY 50 RoLLS (300 m /
ROLL).
3. Electric safety Capitolo
4. Cutter replacement
13