Venmar AVS HRV SOLO 1.5ES Guide De L'utilisateur page 13

2. CONTROLS (
2.2 O M
PTIONAL
2.2.2 D -T
ECO OUCH
H
OW TO SET THE RELATIVE HUMIDITY
Setting the relative humidity level allows to select the maximum desired indoor humidity level (in
percentage). This value will be used to start the dehumidistat override (air exchange in high speed).
U
SE
ARROW TO CHANGE TO
OR
RECIRCULATION
IN STANDBY
1
OFF in stand by: On 20 min/h mode, the ventilation unit is OFF during 40 minutes and exchanges
2
RECIRCULATION in stand by: On 20 min/h mode, the ventilation unit recirculates the inside air
' )
CONT D
C (
AIN ONTROLS
RECIRCULATION
OR
Press and hold OK for 3 sec. to access the settings menu. The
backlight will be activated during all the procedure.
The Relative humidity arrow and value will flash
(default setting: 45%).
OR
Press OK button to accept the new value and go to next settting.
Two lines are flashing to show that OFF¹ is in stand by (default
configuration setting).
UP DOWN
OR
.
Recirculation arrows are turning and rE flashes to show that
RECIRCULATION² is in standby.
Press OK button to accept and quit setting menu.
air with the outside on low speed during the remaining 20 minutes of the hour.
This is the default value.
for 40 minutes on high speed and exchanges air with the outside
on low speed during the remaining 20 minutes of the hour.
' )
CONT D
(RH)
LEVEL AND CHOOSE BETWEEN
IN STANDBY
Use UP or DOWN arrow to change the value. The
value changes by 1% increments. Lower value:
30%. Upper value: 55%. Still flashing.
Press OK button to accept and quit setting
menu.
13
OFF
IN STANDBY