Watts Industries WFHTRF-HC Mode D'emploi page 17

2- MASTER HC RF initialisation
To learn (*) the RF thermostat with the receiver
you must put the receiver in "MHC init" mode
(please refer to the receiver leaflet).
Once, on the thermostat you have just pressed
on the (OK) key during 5 sec, then the display
„RF" must be appears.
o The thermostat will send now the RF signal to
the receiver. Check on the receiver the good
configuration.
o On the receiver you can exit the "MHC init"
mode.(Please refer to the receiver leaflet for
this)
Now you can check the RF distance, go to the
room which must be regulated. Put your
thermostat on the final position (On the wall),
17