Watts Industries WFHTRF-HC Mode D'emploi page 16

Once, on the thermostat you have just pressed
on the (OK) key during 5 sec, then the display
„RF" must be appears.
The thermostat sends its configuration address by
radio signal.
o The thermostat will send now the RF signal to
the receiver. Check on the receiver the good
configuration.
o If the RF learning is not made correctly, check
the installation (antenna connection, supply
voltage...)
o If the RF learning between the thermostat and
the receiver is good, put your thermostat in the
off mode
o On the receiver you can exit the "RF init" mode
or configure another standard thermostat.
(Please refer to the receiver leaflet for this)
16