Publicité
Les langues disponibles
Les langues disponibles
KEBBE ACCESSORY (depending on model)
14
ACCESSORIES USED
- Kebbe accessory (r), geared reducer assembly (n) and mincer head (o).
ASSEMBLY
- Fit the screws (o3) to the body (o1) of the metal mincer head.
- Place the nozzle (r2) on the head aligning the two hooks with the two slots on the mincer
head.
- Place the ring (r1) on the nozzle (r2) then the nut (o6) and tighten fully.
- Place this head assembly onto the geared reducer (n).
Remark: this accessory is used without a disc or a cutter.
Tips
The speeds used are those of paragraph 11.
CLEANING
- Unplug the appliance.
- To make cleaning easier, rinse the accessories quickly after use.
- Wash and dry the accessories, they are all dishwasher proof except for:
• the whisk drive body (f1)
• the pulp collector of the centrifugal juice extractor (m4).
• the mincer head assembly (o).
For specific cleaning instructions for the mincer head, refer to paragraph 11c.
- Pour hot water and a few drops of washing up liquid into the blender (k).
Close the lid. Pulse a few times using the pulse button. Unplug the appliance. Rinse the bowl
under running water and leave to dry.
- The bowl (b3) has a seal (b3-2). To clean it, you can put it in the dishwasher or wash it in
hot water.
To fit the seal back onto the bowl, check that the lip of the seal is always facing upwards.
- To make cleaning and storage easier, the handle of the bowl (b4) and that of the blender (k4)
can be removed (they are dishwasher proof).
- In the event of your accessories being stained by foodstuffs (carrots, oranges...), wipe
them with a cloth dipped in cooking oil, then clean as usual.
- Do not place the motor unit (a), the whisk drive body (f1), or the geared reducer (n) in
water or under running water. Wipe them with a damp sponge.
- The blades of the accessories are very sharp. Handle them with care.
STORAGE
Your Odacio food processor is equipped depending on the model:
- With a storage unit (t), which is housed inside the bowl assembly (b).
You can store the vegetable cutter discs (d1), the disc support (d5), the metal cutter (e1),
the plastic kneader (e2) and the spindle (c) in it.
- a cord storage recess inside the motor unit: Store and adjust the length of the power cord to
suit your requirements by pushing or pulling the cord.
32
Publicité
