Troubleshooting
PROBLEM
Motor does not start.
Suction force is
gradually decreasing.
Cord does not rewind
fully.
Vacuum cleaner does
not pick up dirt.
Low or decreasing
suction.
Body overheating.
Static electicity
discharge.
This Vacuum cleaner is approved the following.
EMC Directive : 2004/108/EC
Low Voltage Directive : 2006/95/EC
SOLUTION
• Check cable, pulg and socket.
• Leave to cool.
• Check for blockage and remove.
• Pull the cord out 2-3 m and push down the cord rewind button.
• Check hose and replace if required.
• Please check filter and, if required, clean as illustrated in the
instructions. if filters are out of condition change them to new
ones.
• Please check filters, if required clean as illustrated in the
instruction.
• Please decrease power suction.
• This can also occur when air in the room is very dry.
Please ventilate the room to air humidity become a normal.
Troubleshooting _19