Télécharger Imprimer la page

ACE Instruments ACE one Notice D'utilisation page 5

Alcotest

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Important notes on test execution and self-assessment
After the last sip of alcohol you should wait at least 15 minutes, as there may still be
residual alcohol in the oral cavity, which influences the measurement result. Also smo-
king should be avoided before a test, as cigarette smoke harms the sensor.
For each test you should use a new mouthpiece – not only for hygienic reasons,
but also because an already used mouthpiece can influence the next measurement
result. The mouthpiece could contain residual alcohol, which would affect the new
test result when the same mouthpiece is used again (this for example could show an
alcoholization of a person who hasn`t drunken any alcohol).
If „FLOW" or „FLo" appears on the display, the given breath sample was insufficient or
ended too soon. Blow into the moutpiece for about 4 seconds constantly (without a
break) – preferably as if you were whistling without a sound.
If the same person performs 2 tests consecutively, then wait at least 3 minutes
between the two tests, as a too short waiting time may cause different measurement
results. The air exhaled from the lungs is, after a test, no longer enriched with the
same alcohol content as in the previous test. Therefore, an immediate second test will
indicate a lower test result.
All measured values determined with this breathalyzer are always indicative and not
legally binding.
8
Why the estimated alcoholization and the measurement result in most cases cannot
match
An alcohol test is affected by a lot of different factors which also affect the test result.
Beside the gender, age, body size and body weight, also the body fat percentage and
the amount of body fluid have a big influence.
In addition, the general physical and mental state or the current daily constitution
have to be taken into consideration. Furthermore, the meals eaten before a breath
test (type of content and level of the stomach) and the intake of medication may
influence the measurement.
Other influencing factors are, of course, the type of drink (percentage of alcohol con-
tent in the beverage and its carbon dioxide and sugar content), the drinking rate and
the individual subject's duration of alcohol build-up or degradation in the body.
Some people quickly have a high alcohol content in the blood, with other people it
takes longer until an alcoholization is detected. About 40-50% of the consumed al-
cohol is in the body within 15 minutes, after 30 minutes it is 65% and after 70 minutes
the previously consumed alcohol is 100% absorbed in the body. However, it should
also be noted that some people – partly due to genetic factors – quickly reduce the
alcohol content in the blood, whereas others still have an increased alcohol content in
the blood after a longer period of time.
9

Publicité

loading