Publicité
Les langues disponibles
Les langues disponibles
STORAGE
COLD WEATHER
In temperatures below 20ºF, the Solar Powered Motion-
Activated Dual Head LED Security Light may not work as
well. Normal performance will return when the temperature
rises.
SAFETY TIPS
Do not cut the power wire. Discontinue use if the wire
becomes frayed or broken.
Do not immerse the Motion-Activated Dual Head LED
Security Light in water or other liquid.
Position the cord from the solar panel to the light so that it
is securely fastened and will not move around or cause
someone to trip over the cord.
MAINTENANCE TIPS
The LED lights in your Motion-Activated Dual Head LED
Security Light will last up to 30,000 hours and should
never need replacement.
Over time, the battery pack will lose its ability to hold a
charge and may need to be replaced. To access the
battery pack, remove the mounting bracket and the metal
battery tray. Disconnect the battery pack plug from the
circuit board. Battery pack replacements (3.6V, 2200 mAh,
AA cells) are available for purchase directly from MAXSA
Innovations by calling 703-495-0661.
To keep your Motion-Activated Dual Head LED Security
Light looking new, keep the lens free of dust and deposits
by wiping occasionally with a dry cloth or with warm soapy
water.
OPERATING YOUR SOLAR SECURITY LIGHT
After the Motion-Activated Dual Head LED Security Light
has been mounted and plugged in, it is now ready for use.
Turn switch on top to ON.
The motion sensor rotates and in the back of it are two
adjustment dials. The dial with the + and the - is the Time
dial and the dial with the () and the ( ) is the Lux dial.
The motion sensor rotates and in the back of it are 2
adjustment dials: TIME and LUX. The light has been
factory preset as follows:
TIME - Set at approximately 30 seconds.
LUX - Set for your Security Light to activate at dusk
when motion is detected.
If the above settings are not suitable for your application,
then these may be adjusted using the steps below.
TIME PERIOD ADJUSTMENT [+ AND – ]
The time period adjustment control dial sets the duration
that the Solar Security Light will remain illuminated after
the last detected motion. The time period has an adjust-
able range of 10 seconds to 1 minute.
To decrease the time period, move the dial toward the (
- ) symbol.
To increase the time period, move the dial toward the (
+ ) symbol.
Test the time period by triggering the motion sensor and
measure the time period the light stays on. Adjust the
TIME control until the desired illumination duration is
reached.
A shorter TIME setting will conserve battery life. For
best results, use the shortest TIME setting for your
location as possible.
LUX LEVEL ADJUSTMENT [() AND
( )]
The LUX dial controls the natural light level that triggers
the Solar Security Light and prevents the light from oper-
ating during daylight hours.
Your Solar Security Light comes preset for activation at
dusk.
To adjust for activation in a brighter setting, move the
dial toward bright ()
To adjust for activation in a darker setting, move the dial
toward dark ( ). (Should look like a thin moon).
Once adjustments are made, move sensor back into posi-
tion with the arrows lined up.
EXTENSION SOLAR CABLE
Extension cords for your solar panel are now available.
Each cord comes in 15 foot lengths and has the appro-
priate plugs on either end. Cost is $14.95 for one and
$9.95 each if you buy 2 or more.
Please contact MAXSA Innovations at 703-495-0661 or
orders@maxsainnovations.com to order.
Page 2
Publicité
