EIBENSTOCK EHR 14.1 SK Notice Originale page 14

Attention!
In case of every stop of the machine or a power cut, the
!
lock-on button has to be released immediately by pressing
the ON/OFF switch. So you can avoid an unintentional
restart of the machine (physical hazard).
The stirrer is equipped with an electronic switch. With this switch the speed
can be regulated according to the pressure on the button. Only use the
electronic switch when you want to start or stop the machine in order to
avoid material splashing around. Permanent use with reduced speed can
cause an overload because the motor then gets less cooling air and
therefore the machine will be overheated much faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only be appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance.
observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Environmental Protection
Raw Material Recycling instead of Waste Disposal
In order to avoid damages on transportation, the tool has to be delivered in
solid packaging. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
The tool's plastics components are marked according to their material,
which makes it possible to remove environmental friendly and differentiated
because of available collection facilities.
However, the following points always have to be
14