Mil Status; I/M Monitors - OTC PocketScan OBD II Mode D'emploi

MIL Status

MIL (Malfunction Indicator Lamp) status indicates if the vehicle computer
is telling the MIL to illuminate when the engine is running.
• MIL ON indicates that the Malfunction Indicator Lamp should
be ON.
• MIL OFF indicates that the Malfunction Indicator Lamp should
be OFF.

I/M Monitors

Inspection / Maintenance Monitors provide a snapshot of the Emission
System operations by indicating that the I/M Monitors are Ready or Not
Ready. For an I/M Monitor to be Ready, the vehicle must have com-
pleted a drive cycle (been driven long enough under proper conditions
to have completed a drive cycle). A Monitor must be listed as Ready to
pass an emissions test. If an I/M Monitor is Not Ready, it is because a
drive cycle has not completed.
The Tool will indicate Ready, Not Ready, or Not Applicable for each I/M
Monitor. The Tool supports the following I/M Monitors:
Monitors
Misfire Monitor
Fuel System
Comprehen Comp
Catalyst
Htd Catalyst
Evaporative Sys
Second Air Sys
A/C Sys refrig
Oxygen Sensor
Htd 02 Sensor
EGR/VVT
NMHC Catalyst
NOX Treatment
Boost Pressure
Exhaust Gas Sen
PM Filter
Expanded Name
Misfire Monitor
Fuel System Monitor
Comprehensive Components Monitor
Catalyst Monitor
Heated Catalyst Monitor
Evaporative System Monitor
Secondary Air System Monitor
Air Conditioning Refrigerant Monitor
Oxygen Sensor Monitor
Oxygen Sensor Heater Monitor
Exhaust Gas Recirculation or Variable Valve Timing
Non-Methane Hydrocarbon Catalyst
Nitrogen Oxide Treatment
Boost Pressure
Exhaust Gas Sensor
Particulate Matter Filter
9