Cleaning The Spray Gun; Maintenance; Troubleshooting - Batavia MAXXSPRAY BT-PSG013 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
obtain the most consistent and profes-
sional finish possible.
Switching the spray gun on/off
8.9
a. Switching on
• Insert the plug into a mains power
socket.
• To switch the spray gun on, press and
hold the trigger (7).
b. Switching off
• To stop spraying, simply release the
trigger (7).
• When you are finished working, discon-
nect the plug from the mains power
supply.

9. Cleaning the spray gun

(See Fig. G).
Special clean-up instructions for
use with flammable solvents (must
have a flash point above
21 °C):
• Always flush spray gun outside.
• Area must be free of flammable vapours.
• Cleaning area must be well-ventilated.
• DO NOT SUBMERGE air compressor!
Unplug the spray gun, and trigger the
9.1
spray gun so that the material inside the
spray gun flows back into the container.
Unscrew the container (11). Empty any
9.2
remaining material back into the mate-
rial container.
Pour a small amount of the appropriate
9.3
cleaning solution into the container
(warm, soapy water for latex materials;
mineral spirits for oil-based materials).
Clean container and properly dispose of
cleaning solution.
Refill the container with NEW cleaning
9.4
solution.
Attach the container to the gun and
9.5
plug in the sprayer.
Spray the solution through the gun for
9.6
two seconds in a safe area. Spray again

11. Troubleshooting

Problem
A. Little or no mate-
rial flow
Cause
1. Nozzle clogged.
for two seconds. Unplug the spray gun,
and trigger the spray gun so that the
material inside the spray gun flows
back into the container.
Wipe the exterior of the container and
9.7
gun until clean.
Unscrew the nut (1) and remove the air
9.8
cap (2) and nozzle (3).
Clean the container, suction tube, air
9.9
cap and nozzle with a cleaning brush
and the appropriate cleaning solution.
Never clean nozzle or air holes in the spray
gun with sharp metal objects.
Do not use solvents or lubricants contain-
ing silicone.
Turn both knobs on both sides of the Air
9.10
Compressor Assembly to the "Unlock"
position, pull and separate the spray
gun from the Air Compressor Assem-
bly. (See Fig. B).
(a) Clean the rear of the spray gun with
9.11
the appropriate cleaning solution.
(b) Turn the suction tube anti-clockwise
and pull the suction tube downward to
disassemble it from the spray gun.
Then clean the suction tube with the
appropriate cleaning solution.

10. Maintenance

(See Fig. H).
You should inspect the air filter in the Air
Compressor Assembly to see if it is exces-
sively dirty. If it is dirty, follow the steps
below to replace it.
a. Unplug the spray gun. Remove the filter
cover with your hands directly.
b. Remove the dirty filters and replace with
new ones.
c. Secure the cover back onto the main
housing.
Never operate your unit without the air
filters. Dirt could be sucked in and inter-
fere with the function of the unit.
Solution
1. Clean.
English
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Maxxspray 7063912

Table des Matières