Important Electrical Information; Before The First Use; Contents Of Packing; Intended Use - Batavia MAXXSPRAY BT-PSG013 Mode D'emploi

4. Important electrical information

The tool plug must fit into the socket.
4.1
The plug may not be modified in any
form. Do not use adapter plugs
together with protective-earthed
tools.
Unmodified plugs and suitable sockets
reduce the risk of an electric shock.
Avoid physical contact with earthed
4.2
surfaces such as pipes, heating ele-
ments, stoves and refrigerators. The
risk through electric shock increases if
your body is earthed.
Keep the equipment away from rain
4.3
and moisture. The risk of an electric
shock increases if water penetrates
electrical equipment.
Do not misuse the mains lead by car-
4.4
rying the tool by the lead, hanging it
from the lead or by pulling on the lead
to remove the plug. Keep the lead
away from heat, oil, sharp edges or
moving tool parts. Damaged or twisted
leads increase the risk of an electric
shock.
If you work outdoors, use only exten-
4.5
sion leads that are approved for out-
door use. The use of an extension lead
that is suitable for outdoors reduces the
risk of an electric shock.

5. Before the first use

Remove the machine and all accessories
from the package. Keep the packaging
materials out of the reach of small children.
There is a danger of suffocation!

6. Contents of packing

1× Electrical spray gun
4× nozzles: 2.5 mm (assembled on
machine), 1.5 mm/2.0 mm/3.0 mm
1× Cleaning needle
1× Viscosity measuring cup
1× Cleaning brush
1× Instruction manual

7. Intended use

The Maxxspray paint spray gun is suitable
for applying paint, lacquers, primer, sealer,
stain and interior wall paint.
• Any other usage of or modification to the
appliance is deemed to be improper and
carries a significant risk of accidents.
• The use of easily flammable, combus-
tible paints, lacquers or thinners is
strictly prohibited.
• The intended use also includes an opera-
tion following the operating instructions.
• Any use beyond these parameters can
lead to serious risks and is regarded as
use that is contrary to the intended
purpose.
• The machine is not intended for
commer cial use.

8. Assembly

(See Fig. A, B).
Assemble the spray gun into the main
8.1
housing
• Insert the spray gun (16) into the main
housing (5) in the "open lock" position on
the main housing. Turn in clockwise
direction.
• Lock the main housing and the spray gun
set with the quick release lock (9).
Aligning the suction tube
8.2
(See Fig. C, G).
• If you are going to be spraying in a down-
ward direction, the angled end of the
suction tube (17) should be pointing
toward the front of the gun.
• If you are going to be spraying in an
upward direction, the angled end of the
suction tube (17) should be pointing
toward the rear of the gun.
• By pointing the suction tube in the proper
direction, you will not have to refill the
container as often.
Material preparation
8.3
Viscosity
• The appliance can process spray materi-
als up to a maximum 100 DIN
ity). You can determine the viscosity
(thickness) of the substance with the
supplied measuring cup using a simpli-
fied measuring procedure.
• Before spraying, the material being used
may need to be thinned with the proper
solvent as specified by the material man-
ufacturer. Never exceed the thinning
English
. (viscos-
-s
9