Climadiff CLIMA24R Notice D'utilisation page 37

8. TROUBLE SHOOTING
You can solve many common air conditioner problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEME
Appliance doesn't work
Cooling function (« COOL » mode) of the
appliance is not efficient
Appliance seems to make too much noise
Compressor doesn't work
Remote control doesn't work
CAUSE POSSIBLE

Not plugged in

The appliance is turned off

The circuit breaker tripped or a blown fuse

Ambient temperature is too low or too high
(recommendations: 7 ° -35 ° C / 44.6 ° -95 ° F)

(« TIMER »
Timer
corrected set

Water full alarm is on

In cooling mode, the room temperature is
already lower
temperature. And conversely in hot mode
where the ambient temperature is already
higher than the set temperature

In dehumidifier
temperature is too high (> 17 ° C / 62 ° F)

Check if nothing is blocking air inlet/outlet

Make sure that there is no heat or cold source
in the room (heating, sun, opened window,
etc.)

Strainers are too dirty and covered by dust

Set temperature is not appropriate

Fan speed set in not the correct one

Make sure that you have correctly removed
all packing material

Make sure that the air conditioner is stable
and level

Make sure that the surface on which your
appliance is perfectly flat

Make sure that compressor protection is not
activated

Distance between
appliance is too big

The remote control is not pointed towards the
mode) hasn't been
than the requested
mode, the ambient
remote control and
37