Climadiff CLIMA24R Notice D'utilisation page 30

Install the heat pipe assembly
 Screw the entire heat pipe assembly (exhaust fitting end) into the exhaust port on the rear panel
(counterclockwise).
 Connect the other extremity of the heat pipe to the window sealing plate.
 Install the window kit on the nearest window. Make sure there are no obstacles at a distance of 50 cm
around the window to ensure proper air evacuation.
Caution:
The length of the exhaust hose shall be 28-150 cm (adaptor included). For energy savings, it's
1.
recommended to use the pipe at its minimum size.
2. The length of the exhaust hose is based on specifications of the air conditioner. Do not use
extension tubes or replace it with other different hoses, or this may cause a malfunction.
Install the body

Move the machine with installed heat pipe and fittings before the window, and the distance between
the body and walls or other objects shall be least 50 cm.
 Elongate the heat pipe and snap the flat end
sealing plate assembly.
 The flat end of the heat pipe joints must be snapped into place.

The pipe cannot be distorted nor has substantial turning (greater than 45 °). Keep the ventilation of the
heat pipe unobstructed.
Install the window sealing plate assembly
 Half open the window, and mount the window sealing plate assembly to the window (as shown in
pictures here below); the assembly can be placed in horizontal and vertical direction.
 Pull various components of the window sealing plate assembly open, adjust their opening distance to
of the heat pipe joints into the elliptical hole of the window
30