Publicité
Les langues disponibles
Les langues disponibles
The parameters that can be set are:
On
OFF = serial port disabled
Set Baud Rate. Selectable values: , , or
Set Parity. Selectable values: , or
ON = print only when reading is stable
OFF = print regardless of stability
ON = Send data continuously over serial port
OFF = Only send data when [PRINT] is pressed
ON = Set the RS-232 to send data periodically. Range 1 to 999 seconds
OFF = No periodic data transmission
Format of serial output data. Selectable parameter from:
SINGLE
STANDARD = Serial data output sent in standard format
FORM 1
FORM 2
13.4 FORMAT OF CUSTOM FORMS #1 and #2
If FORM1 or FORM2 is selected, the format be changed by the user using a selection of
available data. By default the 2 forms are the same as the standard form unless changed
by the user as below.
When "" or "" is selected, the user can set the information to be printed on
each line of the form. Pressing the [Up] or [Down] keys will cycle through the options
available. The options are:
Instrument ID number
Serial Number
Time
Date
Net Weight (Gross weight – Tare Weight)
Gross Weight
Tare Weight
Unit weight in parts counting mode
Number of items in parts counting mode
100% weight in percent weighing mode
Percentage of reference weight in percent weighing
Low Limit when check weighing (Not used)
High Limit when check weighing (Not used)
Inserts a blank line
Signifies the end of the report
(When END is entered the display returns to the Sub-menu)
Enter the data to be printed on the first line by pressing [Up] or [Down] to cycle through
the options. If the current information is OK then press [Setup] to move to the next line.
e.g. "", "" – will print date on first line of output form.
© Adam Equipment Company 2017
= serial port enabled
= Serial data output sent as a single line
= Serial data output sent in custom-designed format FORM 1
= or FORM 2
(See section 13.4).
35
Publicité
