Publicité
Les langues disponibles
Les langues disponibles
13
SUPERVISOR MENUS
Pressing the [Setup] key while in normal weighing gives access to the menus.
When [Setup] is pressed and the Supervisor Passcode is not enabled the display will
allow access to the Supervisor menus. If passcode is enabled, the balance will ask for it
by displaying "" shortly followed by displaying "".
If a passcode is incorrectly entered then the message "" will flash and the display
will return to "" or "".
If the passcode has been enabled and correctly entered, the balance will allow the
operator to access the Supervisor's menus by which the user can enable/disable weighing
units or modes, set balance parameters for the conditions, set time and date, set
parameters for the RS-232 interface, calibration parameters and security parameters.
The display will show the first menu item "". The [Up] and [Down] keys will cycle
through the main menu items and pressing [Setup] will enter the sub-menu, or options can
be set. Press [Mode] to exit out of a sub-menu, or [0/T] to return to normal weighing
13.1 ENABLE WEIGHING UNITS
When "" is displayed, press [Setup]. The right hand side of the display will show the
symbol for the first unit, e.g. carats, ct, together with its enable state "" or "". The
Supervisor can then enable or disable the carats unit by using [Up] or [Down]. Pressing
[Setup] will confirm the setting and will advance to the next weighing unit. Repeat for
each weighing unit in turn. Note: Grams, g, is always enabled.
Press [Mode] to advance to setting of the next menu or press [0/T] to return to
normal weighing
13.2 ENABLE WEIGHING MODES
The same steps are followed to enable or disable the weighing modes:
Press [Setup] when "" is displayed. The top of the display will show the symbol for
Parts
the first mode e.g. Parts Counting ("
") together with its enabled state "OFF" or "On".
The user can enable or disable the parts counting mode by using [Up] or [Down].
Pressing [Setup] will confirm the setting and will advance to the next weighing mode.
Repeat for each mode in turn.
Press [Mode] to advance to setting of the next menu, or press [0/T] to return to
normal weighing
13.3 ENABLE SERIAL INTERFACE PARAMETERS
The parameters affecting the serial interface are set in a similar manner to the other
parameters.
Note: The balance must be power-cycled to apply changes to serial port settings.
Press [Setup] when "" is displayed to enter the sub-menu.
34
© Adam Equipment Company 2017
Publicité
