Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
38 • English
you can use non-foaming bath salts in the water.
Arrange a comfortable sitting position and then the appliance can be con-
nected to the mains.
Always place your feet in the footbath or remove them while in a sitting
position. Never use the appliance in a standing position or stand up in
the unit!
Switching on
The 4-step switch (a) should be turned on and the desired position
chosen:
Stand
Functie
0
UIT
1
MASSAGE = vibrerende massage, te gebruiken met of zonder
water
2
HEAT-WHIRL = verwarming en bubbelbad met water
3
HEAT-WHIRL-MASSAGE = verwarming, bubbelbad en vibrerende
massage met water
Heating
A gentle heater has been built underneath the foot rest of the massager. By
switching on the heating it can be avoided that the warm water cools down
quickly. The heater is not suitable for heating cold water.
Functions
Switch setting 1: Vibratory massage with and without water
For quick use you can have a foot massage without water. Place your
feet - with our without socks - on the bottom of the footbath and turn the
operation switch to setting nr. 1. The heating function is switched off.
Switch setting 2: Heating with whirl bath massage
The water is ejected through fine holes creating air bubbles which caress the
feet and massage the skin in a gentle way. This is enjoying and relaxing. The
positive effect of the whirl bath can be increased by the use of a suitable
bath oil, however you may only use non-foaming products. Especially
refreshing in warm weather is the use of the whirl bath with cold water.
For all settings with the whirl bath function the appliance should always be
filled with water.
Switch setting 3: Heating with whirl bath and vibratory
massage
If you chose this function the vibration function and the whirl bath massage
can be simultaneously used. The combination of both has a positive effect
and increases your enjoyment.
› Acupressure attachment (c)
• Attach the acupressure attachment in a comfortable position on the middle
bridge of your appliance. The attachment must engage in the two depressi-
ons on the left and right.
• To remove the acupressure attachment, press the two buttons together
as shown in fig. 2 until the attachment is released and can be pulled off
upwards.
Publicité
Table des Matières
