MO-EL GIROSOLE Emploi Et Entretien page 15

parts. Ensure that the heater is aiming its warmth into the target area
by adjusting heater angles as necessary by using the adjustment de-
vice on the bracket (fig. 6).
In unoccupied premises it is recommended that the heating system
is switched off and isolated from the electrical supply.
Avoid exposing skin to the rays of the appliance for distances
less than 50 cm.
Avoid exposing eyes to the rays of the appliance for distances
less than 2.70 m.
Do not use it in small rooms used by people who are unable to leave
such rooms on their own unless they are under constant surveillance
or unless the product is in the version with the suffix ED. In this case
the heating appliance does feature an external device to control am-
bient temperature.
All users should be made aware of all aspects of operation and safety
and these instructions should be retained for reference.
6. CLEANNESS
Every mainteinance operation should be done when the appliance
is disconnected from the power supply. Mo-El Girosole heaters con-
tain no moving parts and therefore very little maintenance is required
other than to ensure that there is no excessive build-up of dust/dirt
on the reflectors or emitters as this can cause overheating and pre-
mature emitter failure. To clean the appliance, wipe off with a damp
cloth.
7. MAINTENANCE
The lamps used in the Girosole are robust and if knocks and shock
vibrations are avoided, they will last for around 5000 hours. When
changing the lamps, also the silicon bumpers connected with each
lamp must be substituted. They should be substituted even before
if there are signs of aging. Due to the special sealing and anti-shock
design of the heater, the emitters are not intended to be user re-
placeable. Please ensure that all emitters are replaced via the Mo-El
service network.
The accumulation of limestone or incrustations reduces the life and
15