MO-EL GIROSOLE Emploi Et Entretien page 14

fixing point on the ceiling, ensure that the surface is flat, level and
solid, and that no electric cables or pipes run beneath it.
1. Use the plastic housing of the Girosole (fig. 12) to determine the
position of the 6 holes in the ceiling. Take care to position the
housing in the desired direction, relative to the exit point of the
cable.
2. Make the 6 fixing holes using a no. 10 diameter drill.
3. Temporarily set aside the housing and push the plastic rawlplugs
into the holes.
4. Carry out electrical installation on the terminal panel of the Giro-
sole according to previous instructions (Ch.2). The power cable
of the ceiling mounted model passes "from above". It must pass
through the cable carrier and also the hole in front of it in the
plastic connector, so as to exit from the upper part of the plastic
connector. The complete process is shown in fig. 11.
5. Insert the cable through the metal tube (fig. 11).
6. Firmly push the metal tube into the plastic connector (fig. 11).
7. Fix the tube to the connector by screwing the two 3.5 x 6 self-
tapping screws into the two opposing holes (fig. 11).
8. Insert the cable into the fixing unit (as shown previously) and
insert this into the metal tube. Ensure that the screw on the unit
is aligned with the tube. Press until a click is heard (fig. 12).
9. Use the Allen screw on the unit to fix it to the tube (fig. 12).
10. Fit the unit to the ceiling by means of the 6 screws supplied,
without tightening.
11. Pull the cable so as to straighten it inside the tube.
12. Tighten the 6 fixing screws into the ceiling.
13. Tighten the Allen screw.
14. Insert the white plastic cover into the hole in the centre of the
Girosole (fig. 13).
5. USE
The essential element of the heater is the halogen filled quartz linear
lamp with a tungsten element. The heater operates at full output
almost immediately. The heating reaches a distance of about 4-6 me-
ters around the appliance (fig. 10).
Every lamp can be switched on with its switch (fig. 6). Before press-
ing the switch, seize firmly the grip and avoid to touch the metal
14