Publicité
Les langues disponibles
Les langues disponibles
CPU Base Clock Apply Mode [Auto]*
f
Sets the applying mode for adjusted CPU base clock.
[Auto]
This setting will be configured automatically by BIOS.
[Next Boot]
CPU will run the adjusted CPU base clock at next boot.
[Immediate] CPU runs the adjusted CPU base clock immediately.
[During Boot] CPU will run the adjusted CPU base clock during boot.
Filter PLL [Auto]
f
Enables or disables the filter PLL for CPU. This item appears when the installed CPU
supports this function.
CPU PLL Trim Offset [Auto]
f
Sets a offset value to help the CPU stability when overclocking. The final result could
vary with the CPU. This item appears when the installed CPU supports this function.
DRAM Reference Clock [Auto]*
f
Sets the DRAM reference clock. The valid value range depends on the installed CPU.
This item appears when a CPU that supports this adjustment is installed.
DRAM Frequency [Auto]
f
Sets the DRAM frequency. Please note the overclocking behavior is not guaranteed.
Adjusted DRAM Frequency
f
Shows the adjusted DRAM frequency. Read-only.
Extreme Memory Profile (X.M.P.) [Disabled]
f
X.M.P. (Extreme Memory Profile) is the overclocking technology by memory module.
This item will be available when the memory modules that support X.M.P. is installed.
[Disabled]
Disables this function.
[Profile 1]
Uses profile1 settings of XMP memory module.
[Profile 2]
Uses profile2 settings of XMP memory module.
Memory Try It ! [Disabled]
f
It improve memory compatibility or performance by choosing optimized memory
preset.
DRAM Timing Mode [Auto]
f
Selects the memory timing mode.
[Auto]
DRAM timings will be determined based on SPD (Serial Presence
Detect) of installed memory modules.
[Link]
Allows user to configure the DRAM timing for all memory channel.
[UnLink]
Allows user to configure the DRAM timing for respective memory
channel.
Advanced DRAM Configuration
f
Press Enter to enter the sub-menu. User can set the memory timing for each/ all
memory channel. The system may become un-stable or un-bootable after changing
memory timing. If it occurs, please clear the CMOS data and restore the default
settings. (Refer to the Clear CMOS jumper/ button section to clear the CMOS data, and
enter the BIOS to load the default settings.)
43
BIOS Setup
Publicité
