Akerstroms SESAM 800 Mode D'emploi page 13

OPERATING MANUAL
12 PAIRING RECEIVER AND TRANSMITTER
If any part of the system has been replaced, the receiver and transmitter need to be paired to-
gether. Follow the steps below (please notice that this is for one transmitter see section 12.1 for
more than one transmitter):
1. Open the lid on the receiver (6 screws).
2. Push the "Learn/Erase" button until LED 7 (see fig. 1) is ON.
3. The Learn Mode will be active for 10 seconds (as long as LED 7 is ON).
4. Press a button on the transmitter. LED 7 flashes 3 times if the learn are suc-
cessful.
5. Mount the lid and tighten the screws with 2.5 Nm.
6. Mount the caps over the screws.
To delete a transmitter from the receiver, push the "Learn/Erase" button until LED 7 is ON.
Continue by pressing the "Learn/Erase" button once more until LED 7 is OFF. Notice that if
more than one transmitter is paired to the receiver this will delete all transmitters.
12.1 Pairing Multiple Transmitters
The delivery settings allow the receiver to learn 1 transmitter (see Figure 9).
For the position of the jumper in the receiver see 8 in Figure 1.
Figure 9. Jumper in place for
one transmitter, default
However, the system is capable of using up to 3 transmitters. To enable this function, power off
the receiver and place the jumper in the J2 (right) position (see Figure 10).
• For safety reasons the receiver is inactive for five seconds when switching
between two transmitters.
• See chapter 12 for pairing instructions.
Document-ID: 947422-000 Multi
Figure 10. Jumper in multiple
transmitter mode, J2
13 (112)
EN
Version: C0