Akerstroms SESAM 800 Mode D'emploi page 10

OPERATING MANUAL
Step 4
Connect wiring for output signals and power supply. Use tie wraps to secure the wire and ensure
that the wiring will not be affected by hot parts and/or exhausts. The power supply (+) to the
EN
receiver must be fused with a system adapted fuse as close to the battery/power supply as pos-
sible.
Output
(see fig. 4)
Button
(see fig. 5)
Table 2.
Step 5
System Check
• Ensure that wiring to all components is correct and all loose wires are cable tied
and secure.
• If necessary pair transmitter (see chap. 12).
• By pressing the buttons on the transmitter, verify that all functions work correctly
as described in table 2. Note that some of the buttons may be set as remaining
(see chap. 13).
Document-ID: 947422-000 Multi
Figure 4.
1 2 3
1 2 3
Functional diagram for installation of cable
Numbering of outputs
4 5 6
4 5 6
10 (112)
Version: C0