Altech Adoucisseur Primeo Mode D'emploi page 36

 

0800 877 200 : Brossette contact.brossette@saint-gobain.com - 0800 877 779 : Cedeo contact-cedeo@saint-gobain.com

This document does not replace the installation manual.

Thank you to refer it on installation and setup steps.
1 - Material

drinking water

Water inlet


3 bar pressure
reductor

Mandatory
 
2 - Water hardness measuring
 


Test reagent
not supplied

Keep the result value, it will be useful on step 8.
 
4 - Adding salt

necessary to recharge : 3 kg.

NB : complete the filling after step 9

and 50 kg of salt for other models.

6 - Connect to power mains socket

Connect the device to the main power Connect the device to the main power Connect the device to the main power
(standardized plug).
9 - Launching a recharge

Unlock the screen by pressing
Launch the recharge by pressing

Run and check all the recharge cycles:

-
10 - Hardness of water setting 
Wit a flat screwdriver, residual water hardness can be set. It must be in a range from 8°f to 12°f.
Unscrew a first time the screw on top of its place, then adjust to obtain the desired value.
- 
NB: unscrew to rise and screw to reduce the hardness.
Measure again (step 2) to check your setting. Let the water flow for 1 to 2 minutes after each adjustment.
-

Your Altech softener is properly installed. Check it during the next 48 hours.
11 - Y our Comap WT softener is properly installed. Check it during the next 48 hours.
If you want a commissioning provided by an approved partner, please connect to our website:

www.mes-adou-primeo.fr and fill in the form.
HELP ON YOUR DEVICE START UP.
Make sure there is all following elements on your installation:
Tap for
Supplied test strips
OR
Add the salt EN 973
with maximum 15 kg of salt
for the 8 l model
7 - Time setting
230 V~ 50-60 Hz
To access the menu press
Use the
to select "set clock".
Press
Set the time, using the
Press
Press
8 - Water volume setting (previous page)

and simultaneously.
1. Isolating valve before installation.
2. Standard isolator. Mandatory.
3. Sediment filter. Strongly advised
(filtering delivered with the softener).
4. Hoses
5. Electric transformer. Mandatory.
Mandatory.
6. Brine evacuation pipe.
7. Overflow evacuation pipe.
8. Siphon with isolator. Mandatory : salt storage tank overflow and
head drain must be connected to the sewer with an isolated
 
siphon preventing sewer to reject waste water In the system.
3 - Adding water

5 - Checking Bypass and outlet/inlet
Inlet
and keys
to access the menu.
and
to confirm.
to quit the menu.
(previous pages 33 and 34)

Phase 1
Phase 2
Phase 3
Phase 4

35
Mandatory.
Mandatory.
Put some water in the bottom of the tank:
- 4 liters for an 8L softener,
- 15 liters for other models.
Outlet
Ensure that the mounting
clamps are correctly installed
and check outlet/inlet.
Put the Bypass on.
NB : to unlock the screen
press
10 seconds.
keys.
Water to sewer
Water level in salt tank goes down
the water to sewer
Water level in slat tank rises
Water to sewer
RI820246 - 06/18 Ind A
and