Power Fist 8968828 Manuel De L'utilisateur page 10

8968828
1. Turn counter clockwise to tighten the
arbor bolt.
2. Turn clockwise to loosen the arbor bolt.
3. To remove a cutting disc, reverse the
above installation procedure.
INSTALLING A DUST EXTRACTION MACHINE
WARNING! Dust can be dangerous. It is strongly recommend to use a
suitable dust extraction machine (not supplied) to keep the workplace as
clean and safe as possible.
The suction hose from the dust extraction machine should be attached to dust
extraction port of the saw.
1. Remove the rubber cap from the dust
extraction port and store it when not in use.
2. Push the connection hose from the dust
extraction machine into the dust extraction
port of the saw (Fig. 4)
3. Follow all instructions supplied with the
dust extraction machine.
4. Ensure that the hose and power cable of any
attached dust extraction machine do not
pose tripping (or any other) hazards to the
operator.
5. When the dust extraction machine is no longer required, remove it from the
saw and replace the cap to the dust extraction port.
ON/OFF TRIGGER SWITCH
This machine is equipped with a safety-start trigger switch. To start the tool:
10
12 in. Electric Concrete Saw
For technical questions call 1-800-665-8685
V4.0