camry Premium CR 7907 Mode D'emploi page 8

socket. Move the device carefully, so as not to spill the water in the water pan at the bottom of the housing. Then put some container (not
included in set) under the drainage hole (8), unscrew it and remove the cap closing the opening – look at picture 7. Let the water to pour
out, during drainage, the housing can be tilted slightly backwards. Then install it again and turn on the device.
CONTINUOUS DRAINAGE: In the COOL and DRY mode, you can connect the pipe (not included in set) to the constant drainage – picture
9. To do this, unscrew and remove the cap closing the opening of the continuous water drainage (7). Then, set drainage hose (not included
in set) into the water outlet and put the other end in a capacious vessel.
PROTECTION DEVICES
1. Frost Protection Function: in cooling, dehumidification or economic power saving mode, if the temperature of the exhaust pipe is too low,
the machine will automatically enter protection status; if the temperature of the exhaust pipe rises to a certain temperature, it can
automatically revert to normal operation.
2. Overflow Protection Function: read DRAINAGE INSTRUCTIONS chapter. After the water is emptied, the machine will automatically
return to the original state.
3. Automatic Defrosting: the device has automatic defrosting function: during defrosting, heating symbol on the display screen will flash.
4. Protection Function of the Compressor: to increase the service life of the compressor, it has a 3 minutes delay booting protection
function after the compressor is turned off.
CLEANING & MAINTENANCE
Cleaning: before cleaning and maintenance, turn off the device and unplug the plug.
1) Housing cleaning
Clean with surface of device with a wet soft cloth. Don't use chemicals, such as benzene, alcohol, gasoline, otherwise, the surface of the
device will be damaged or even the whole machine will be damaged.
2) Net filters cleaning
If the filter is clogged with dust, then the effectiveness of the device is reduced, be sure to clean the filter once every two weeks. Clean the
upper and down filters frames after remove them from the back side of device – picture 8.
* Upper filter screen frame: Clasp the wedging block of the filter screen frame with hands. Force down from the outside to remove the filter
screen frame. Unscrew four screws fixing the filter screen and the rear housing to remove the filter screen (as shown in picture 8) .
* Lower filter screen frame: Hold the handle of the filter screen frame, and pull it outward gently to remove it.
* Put both filter screens into warm water with neutral detergent (about 40 ℃ / 104 ℉) and dry them in the shade after rinsing clean.
STORAGE
If the device will be unused for a long time, please do as following :
1. Pull out drainage plug (8) to flow out water.
2. Let the device runs under fan mode for 2 hours to dry out the device's internal.
3. Turn off the device and pull out plug .
4. Clean and dry filters, then reinstall them.
5. Pull out exhaust pipe for safe keeping .
6. Put the machine into plastic bag , and place it on a dry place.
7. Remove batteries of the remote control and keep them properly.
TROUBLESHOOTING
Problem I.: The air conditioning does not work.
Reason 1: There is no electricity. So, turn it on after connecting it to a socket with electricity.
Reason 2: The water full control lamp displays "FL". So, discharge the water.
8