Bosch GST 80 PB Professional Notice Originale page 7

(21) Parallel guide with circle cutter
Technical Data
Jigsaw
Article number
Stroke rate control
Stroke rate preselection
Pendulum action
Rated power input
Power output
No-load stroke rate n
0
Stroke
Max. cutting depth
– in wood
– in aluminium
– in steel (unalloyed)
Max. cutting angle (left/right)
Weight according to EPTA-Procedure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Noise/Vibration Information
Noise emission values determined according to
EN 62841‑2‑11.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 82 dB(A); sound power level
93 dB(A). Uncertainty K = 5 dB.
Wear hearing protection
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 62841‑2‑11:
Cutting boards with saw blade T 111 C:
2 2
a = 4.5 m/s , K = 1.5 m/s ,
h,B
Cutting sheet metal with saw blade T 118 A:
2 2
a = 3.5 m/s , K = 1.5 m/s .
h,M
The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure and may be used to com-
pare power tools. They may also be used for a preliminary
estimation of vibration and noise emissions.
The stated vibration level and noise emission value repres-
ent the main applications of the power tool. However, if the
power tool is used for other applications, with different ap-
plication tools or is poorly maintained, the vibration level
and noise emission value may differ. This may significantly
increase the vibration and noise emissions over the total
working period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
Bosch Power Tools
A)
(22) Circle cutter centring tip
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and application tools, keeping their hands warm,
and organising workflows correctly.
Assembly
Pull the plug out of the socket before carrying out any
u
work on the power tool.
Inserting/changing the saw blade
When fitting or changing the saw blade, wear protect-
u
ive gloves. Blades are sharp and can become hot when
used for prolonged periods of time.
Selecting the saw blade
You will find an overview of recommended saw blades at the
end of these operating instructions. Only use saw blades
with single lug shank (T shank). The saw blade should not be
longer than required for the intended cut.
Use a narrow saw blade when sawing tight curves.
Inserting/removing the saw blade (see figure A)
Set the pendulum action adjusting lever (6) to level III be-
fore inserting the saw blade (9).
A)
GST 80 PB
3 601 E81 2..
–
–
●
W 580
W 350
−1
min 3100
mm 26
mm 80
mm 20
mm 10
° 45
kg 2.4
/ II
1 609 92A 514 | (26.03.2019)
English | 7
GST 80 PBE
3 601 E81 5..
●
●
●
580
350
500–3100
26
80
20
10
45
2.4
/ II