Publicité
Les langues disponibles
Les langues disponibles
3. STRAPS INSTALLATION
• Install the lower strap first. To do so, screw each strap hook with 2 (V)
screws at 9 in.(24 cm) from the bottom of the wall, aligned with each
column (CF). There are pre-drilled holes on the left edge of each panel
(figure 3.2).
• Insert the strap in each of the strap hooks (L) and flip the screw cover
from the support to hide the screws.(figure 3.1). When the strap is
installed, fasten together using the necessary hardware. See steps 1
and 2 in (figure 3.3). Note that it is very important that the assembly of
the straps should be symmetrical.
• During the assembly, do not try to pull the strap. If the holes are not
aligned. You can choose a looser assembly. The tension in the strap
will be created when the pool is full. Install the second and the third
strap using the same method.
3.2
3.1
Part list for the fastening system
S2: Carriage bolt
S3: Washer
S4: Nylon insert locknut
S5: Lockwasher
4. ATTACHMENT OF THE SKIMMER PLATE
Using a hammer and a chisel, remove the center of the skimmer opening.
Refer to (figure 4.1) for visual support.
The skimmer will need to be installed after the liner. Refer to the skimmer's
assembly instructions in order to ensure a proper installation.
TAÏGA ZONE | TAIGAPOOLS.COM | 12775 RUE BRAULT, MIRABEL, QC, J7J 0C4
3.3
Step 1
Step 1
Step 2
Step 2
IMPORTANT NOTICE - BELT INSTALLATION
Install the straps at their minimum position by manually removing all the
slack around the pool. Never use force (screwdriver or any mechanical
means) to align the holes in the strap assembly. If the straps cannot reach
their minimum positions, use the next holes as shown in example A and
B, or looser, until the straps can be attached. Always use 3 bolts. Ensure
that the top and bottom straps are attached at the same hole positions.
Tighten the nuts until the lock washers are completely compressed and
there is no slack between the straps.
If necessary, distribute the slack in the straps throughout the pool before
filling with water. (figure 3.4)
Always use 3 bolts. THE MANUFACTURER DECLINES ALL LIABILITY
FOR DAMAGES RESULTING FROM FAILURE TO FOLLOW THIS STEP OF
THE PROCEDURE.
3.4
S2
S3
S5
Minimum Position
S4
Example A
Example B
4.1
Strap
Strap hook
3
Publicité
