Publicité
Les langues disponibles
Les langues disponibles
Dear Customer
Congratulations! You have purchased a pool of superior quality and durability. To achieve the best possible results, follow the instructions
carefully. Failure to follow the installation procedures may result in damage to your pool or property and void your warranty. We recommend
that you make a preliminary study of the instruction booklet to familiarize yourself with the different parts of your pool. Make sure that
you understand each step thoroughly before you begin assembling.
WARNING : Be sure you have read and understand the 'Safety Information'
sheets before you begin your pool installation.
WARNING : For your safety, your pool is not designed for diving and/or
jumping head first. Please do not dive. Diving may result permanent injury
or death.
1. SITE PREPARATION
• Choose the best firm ground for your pool. Drive a stake at the center
of the chosen pool site. With a string and another stick, draw a circle
that is 6 inches (15 cm) longer in radius than your pool. Refer to the
(figure 1.1) and the table A below. Remove the grass within this circle
and leave the stake at the center (figure 1.2).
• Do not forget Taïga Zone will not be responsible for any damages
caused to your pool if it is installed on soft or non-levelled ground. Do
not install pool on asphalt, tar, wood, rock or grass covered areas.
• Do not add material or soil to level your pool site. You must dig down
to remove the highest points of your site.
• Any added soil won't give the needed strenght to support the pool's
weight. The entire pool area must be completely levelled.
• Level it using a carpenter's level and a straight board nailed to the
center stake (figure 1.2).
• Have the straight board the same length as the radius of your pool.
Make sure the entire bottom is smooth and free of any foreign
material, such as wood or rocks.
• After you levelled the surface, you can dig to the depth specified in the
table A below and as shown in (figure 1.3).
• Add 2" (5 cm) of compacted crushed stone into hole at pool limit and
add concrete blocks (16"X 8"X 2") on the crushed stone (figure 1.3).
TAÏGA ZONE | TAIGAPOOLS.COM | 12775 RUE BRAULT, MIRABEL, QC, J7J 0C4
ASSEMBLY INSTRUCTIONS
We wish you a most pleasant and refreshing summer.
1.1
1.2
1.3
INSPOLYK_V0_2021-02-26
ROUND POOLS
MODEL CASTEL
1
Publicité
