MELICONI SPEEDY 210 COMBO Mode D'emploi page 15

(only to be performed if you know the specifi c code to be set)
To go to the programming mode, according to requirements, use one of the following pairs of buttons:
VOL + and VOL -
to set the code for the TV part only - (light blue buttons)
P + and P - to set the code for the DECODER part only - (dark blue buttons)
VOL + and P +
to set a single code and control only one device - (whole keypad)
1. Switch to the programming mode by simultaneously
holding down the appropriate pair of buttons.
2. When the indicator light starts fl ashing, release the
buttons and immediately enter the specifi c code
previously found.(e.g.: 1701)
Three long fl ashes indicate a correct setting. If they do not appear, repeat the procedure.
If you set up the remote control using the MANUAL SEARCH procedure, obtain and make a note of the code in use
as follows:
1. Simultaneously hold down the VOL+ and VOL- buttons (if
you want to fi nd the codes of analogue or digital TVs), or
P+ and P- (to fi nd the decoder code).
2. When the indicator light starts fl ashing, release the
buttons and briefl y press the TV/RADIO button.
3. After a pause of several seconds, the indicator light
produces four sets of fl ashes, spaced out, corresponding
to the code to be obtained. Count the number of fl ashes.
Each set of fl ashes corresponds to one fi gure in the code.
Ten fl ashes correspond to the fi gure 0. For example, for
the code 1701 the following fl ashes will be obtained:
Make a note of the code obtained on the label on the inside of the battery cover. You may need it in future.
ENTERING THE CODE DIRECTLY
DISPLAY CODE IN USE
Example of TV code
7
Example
TV Code Decoder Code
Code obtained = 1701
1
7
0
1
13