Brother P-touch 2460 Mode D'emploi page 49

Error Message
SET 6mm!
TAPE EMPTY!
TEXT TOO HIGH!
XX BLOCK
TEXT TOO LONG!
TEXT TOO LONG!
XX BLOCK
VALUE OUT OF
RANGE!
44
Cause
• This message appears if a
6-mm-wide tape cassette is
not installed when printing
an Auto Format template
created for 6-mm-wide tape.
• This message appears if no
tape cassette is installed
when you try to feed the
tape, print or use the
Preview function.
• This message appears if the
size of the text is larger than
the width of the installed
tape.
• This message appears if the
length of the text is longer
than the label length that has
been set with the Length
function.
• This message appears if you
try to print a label that is
longer than the specified
block length.
• This message appears if the
value entered while setting
the Margin, Length, and
Block Length function is not
within the allowable range.
• This message appears if the
values for the blocks to be
printed is not within the
allowable range.
Solution
• Install a 6-mm-wide tape
cassette.
• Install a tape cassette and try
again.
• Reduce the size of the
characters, install a tape
with a greater width, or
select the AUTO text size
setting.
A
• Press , and then select a
longer label length.
• Reduce the size or width of
the characters, or select the
AUTO text size setting.
• Select a longer block length.
• Type in a value that is within
the allowable range.