Roadstar DAC 4416-M Manuel D'instructions page 4

MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other power
sources may damage the unit.
CAUTION
To prevent electric shock disconnect from the mains before removing cover. No user serviceable
parts inside. Refer servicing to qualified service personnel.
SAFETY PRECAUTION
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: 230V 50Hz - AC only
This symbol means that this unit is double insulated. An earth connection is not required.
POWER SUPPLY
Remove the stereo carefully from the box, retaining the packaging for future use.
AC POWER OPERATION
Connect the plug to a mains power inlet 230V AC ~ 50 Hz.
FM TUNER
Operation
• Set the Function Selector (6) to the FM/PHONO position.
• Tune to the desired radio station by turning the Tuning control (10/11).
• Adjust the Volume level (9) to the desired level
• To switch off the radio press for three seconds the ON/OFF button.
ANTENNA
• For FM reception there is a built-in FM antenna wire (17) at the rear of the unit. Move the wire
around to obtain the best reception.
FM & FM-STEREO RECEPTION
• Stereo reception is possible when the tuned FM station is broadcasting in stereo.
TURNTABLE OPERATION
Preparation
Open the Record Player Cover.
Release the Tonearm Clamp, and remove the stylus protector.
English
3
Listening to Records
1.
2.
central spindle when playing 17cm EP records.
3.
4.
5.
6.
7.
8.
9.
English
4
IMPORTANT! Unscrew the transport screw (15) before start playing the disc
Set the Function Selector (6) to the FM/PHONO position.
Place a record on the turntable, over the central spindle. Place the EP adapter over the
Set the Speed Selector (14) to 33, 45 or 78 rpm according to the record.
Release the tonearm clamp, and remove the protective cap from the stylus.
Lift the Tonearm with the Tonearm Lift Lever (13).
Move the tonearm to the beginning of the record, or to the start of a particular track.
Gently lower the tone arm onto the record with the Tonearm Lift lever to start playing.
When the record is finished the tonearm will automatically stop and return from the
trecord to the rest .
To stop manually, lift the tonearm from the record and return it to the rest.
Notes: Do not stop or turn the platter manually.
Moving or jarring the turntable without securing the Tonearm clamp could result in damage to the
Tonearm.
Replace the protective cap on the stylus when not in use.
AUX-IN FUNCTION
You can connect the external Audio signals to through the Line IN socket (16) with an cable (not
included).
SPECIFICATIONS
Power Supply
AC: 230V ~ 50Hz
Radio Frequency Coverage
FM: 87.5 - 108MHz
Output power 2 x 1.5 W RMS
Design and specifications are subject to change without notice.