Aim TTi 1908 Instructions page 55

Frequency
Range
100Hz
1000Hz
10kHz
100kHz
Accuracy specifications for 100Hz range apply only at slow measurement speed of 4 readings
per second.
Range:
Input sensitivity:
Capacitance
Scale length:
Range
10nF
100nF
1uF
10uF
100uF
Temperature
Linearised measurement for PT100 or PT1000 RTD probes, 2-wire or 4-wire
measurement display in ºC or ºF.
RTD
PT100
PT1000
Accuracy specifications apply to multimeter only, they do not account for additional probe accuracy
errors.
Continuity and Diode Test
Continuity:
Diode Test:
Maximum Open Circuit
Voltage:
Maximum Input:
TRIGGER
External Remote Trigger (TTL/CMOS)
Connection:
Input:
Output:
Accuracy Resolution
0.01Hz
0.01% ± 1 dig. 0.1Hz
1Hz
10Hz
10Hz to 100kHz
Better than 30mVrms (100mV range); better than 10% of range for
all other Vac and Iac ranges.
1200 counts
Accuracy Resolution
10pF
2% ± 5 dig. 100pF
1nF
10nF
5% ± 5 dig. 100nF
Range
-50 to 400°C
-50 to 400°C
1000Ω range selected; audible tone sounds for impedance <10Ω.
Test current approximately 1mA; displays voltages up to 1.2V.
3.5V
1000V DC or AC rms, any range.
Terminal block on rear panel.
Input to the LED of an opto-isolator through 1kΩ resistor. Apply >+3V
to trigger remote input. Max. Voltage 10V.
Opto-isolated open collector output, conducts for 250ms on
completion of input trigger. Max. off-state Voltage: 10V. On state sink
current 2mA (typical).
Page 54
Accuracy
0.05% ± 0.5°C
0.05% ± 0.5°C
Resolution
0.1°C
0.1°C