Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Circuit Priming
N.B.: Upon first use, after dispensing steam or when the
water tank is empty, the machine's water circuit must
always be primed.
This machine, featuring a pump to brew coffee, is equipped
with a self-priming system.
Put an empty cup below the steam frother (8), press the hot
water button (4) and turn the steam knob (25) clockwise.
You will hear the noise of the enabled pump and after a few
seconds water will come down from steam rod (8).
When the cup is filled close the steam knob (25) and press
the hot water button (4) again.
NOTE: The temperature ready-light (7) will automatically
flash as the machine boiler heats. After switching on
the machine for the first coffee, wait 6 minutes until the
machine has fully heated up, while for all subsequent
coffees the machine will be ready to use.
Another feature of the machine is the "no-drip system",
eliminating most of dripping from brewing head (14).
After coffee brewing, however, a little dripping may occur due
to wet coffee grinds in the filter-holder.
Caution: Never operate pump without water
in machine as damage to the pump may occur.
Damage of pump run without water is not
covered by warranty.
Using the machine for the fi rst time or
after a period of inactivity
This simple operation ensures an optimum brewing and must
be performed:
- at first start-up;
- when the machine remains inactive for a long time (more
than 2 weeks).
NOTE: Dispensed water must be emptied into an adequate
drain. It is not suitable for food use. If the container fills
up during the cycle, stop dispensing water and empty it
before resuming the operation.
A (Fig.02) - Rinse the tank and fill it again with fresh
drinking water.
B (Fig.03) - Place a container under the steam wand
(Pannarello). Press the button for dispensing hot water
(4); the indicator light of the button will start blinking.
Open the knob (25) slowly by turning it clockwise.
C Dispense the whole water tank from the steam/hot water
wand. To stop dispensing, close the knob (25) by turning
it counter-clockwise and press the button (4) again.
D (Fig. 02) - Fill the tank with fresh drinking water.
E Insert the filter holder into the brew unit from the bottom
(14) and turn it from left to right until it locks into
place.
F Place a suitable container under the filter holder.
G Press the brew button (6) and dispense all the water in
the tank. Once the water tank is empty, stop dispensing
by pressing the brew button again (6). At the end, empty
the container.
H Remove the filter holder from the unit by turning it from
right to left and rinse it with fresh drinking water.
I The machine is now ready to be used.
For further information on how to dispense hot water, please
refer to sections "How to brew a good Espresso
Coffee" and "Making Hot Water".
• 14 •
Publicité
