Faber Fortezza Isola Manuel D'instructions page 8

High Ceiling Chimney Instructions Continued
4. Slide lower chimney cover over the chimney support and
extension chimney cover and attach to the bottom of the
support using the 2 screws provided.
A. Chimney extension kit assembled to hood
assembly with chimney covers attached
Range Hood Installation Continued
1. Using two or more people, lift the hood up against the
chimney support and attach canopy to the chimney support
using the 4 hex washer head bolts provided. Tighten bolts
securely.
2. From the underside of the hood, plug control
cables together as shown.
A. Screw
B. Upper chimney extension cover
C. Lower chimney extension cover
A. Chimney support
B. Hood
C. Hex washer head bolts
3. Insert each connected cable into a black plastic connector
box half.
4. Place the top half of the connector box over the bottom half
of the connector box and screw the 2 halves together using
the 4 screws provided for each connector box.
A. Screws
B. Connector box half
5. Using the 2 longer screws provided for each box, attach the
assembled connector boxes to the metal flange.
6. Turn the power supply on. Turn on blower and lights. If the
Range Hood does not operate, check that the circuit breaker
is not tripped or the house fuse blown. If the unit still does not
operate, disconnect the power supply and check that the wiring
connections have been made properly.
NOTE: To get the most efficient use from your new
range hood, read the "Use and Care Information"
section
Version 06/12 - Page 8